Kitchen & appliance install
A new Whirlpool over-the-range microwave hung above a gas range. We cut the cabinet above for the exhaust and power cord, set the vent adapter, ran and connected the duct, then mounted the unit level and tested it.
The customer had a new over-the-range microwave and no way to vent it. The cabinet above was solid, with no opening for the exhaust or the power cord.
We cut the cabinet floor for the vent and cord, set the vent adapter, ran and connected the flex exhaust duct, routed the cord to the outlet inside the cabinet, and hung the microwave level and tight to the cabinet. Then we tested the fan, the light and the oven before we left.
More work
A bay-window ceiling with water damage. We opened it up, cut out the damaged drywall, put in a new section, then taped, skimmed and sanded it until it blended back into the ceiling.
An old fence line along the side of a house, torn out down to the posts and replaced with a new cedar fence and section by the gate.
A raised wood deck with two stair runs, repainted top to bottom: deck boards, rails, balusters, posts and every tread.
A rotted corner on the back of a house, where the second-floor overhang meets the soffit. We tore out the bad wood, built the corner back with new trim and painted it to match.
A section of bathroom ceiling over the shower, cut out and replaced with new drywall, then taped, skim-coated and finished so it blends in next to the exhaust fan.
An old, failing privacy fence replaced with new pressure-treated panels, including a run set on top of an existing retaining wall.